COVID Projects

Thanks for joining the ranks sir That setup looks mint!!

 

if i had a N2 bottle, i’d yank off the primaries and finally get around to re-valving them.

if i had some mdf, i’d finish up the solar wiring/mounting.

but, i have neither nor can i go get them, so i clean bikes, bleed brakes and dream about dirt therapy. tune and retune the stereo. redo the solar wiring diagrams. ride on the trainer on the back porch.

also, doing a bunch of planning for the studio so that i can be moving at speed when the world spins back up. studying. experimenting. working on new techniques. testing some ideas. i have time now that i won’t have later.

 

Did some fluid changes on the car, next is to finally swap my bumper caps, grill and hood bulge

 

I built a drawer system for my 4runner. I'm not a woodworker by any means, and have only simple power tools. Still turned out ok in my book.

I have added a 1/4" thick drawer top to the left drawer so it can be used as a table.



I'm considering installing a spray in bedliner into my new Tundra as the next project. I hear Raptor Liner smells like a devilfart passed through an evil onion though.

 

Para cord wrap grab handles, Lamin x over fog lights, anytime fog mod, rear diff breather mod, startup screen mod, screen off mod, any of these should cost less than 15 bucks. probably way less.

 

I refinished a couple of CZ82's using Gun Kote, which is very similar. Just like Raptor Liner, it smells like chemical death. Don't use your inside oven or your wife will move out.