Yoda4ever's build

Method NV 18×9 wheels
295/70/18 Cooper stt pro
Bilstein 6112/ 5100's
Level Load air bags
Custom built rock sliders
Zone offroad uca's
Coachbuilder bumper shims
Differential drop kit
Bed liner
1 inch steel rear block

Future plans:

Change out grill
Clazzio leather seat covers
Possible carrier bearing drop
Upgrade headlights

 

Solid start

 

Okay, so i got these today....Not cheap after exchange rate, shipping, and duty fees, but hoping these save me from having to trim my liner. Lift installation later this week

 

Welcome from NC!

 

The suspense is killing me ...

 

Edit: Never mind, found it.
http://www.boss4x4.com/product-p/cb2-fbs.htm

 

http://www.boss4x4.com/product-p/cb2-fbs.htm

 

So a few setbacks... Tires hopefully showing up in the morning 6112's on top setting ( almost 3") 1 inch steel block in the back with 5100's, plus airbags set at 20 psi. and a diff drop. More to come !

 

In process, stay tuned..

 

Looks like a great start. Going to look good when those new wheels and tires get put on.

 

And there it is

 

Sorry and thank you Joon, obviously a rip off but consider it a compliment!

 

Looks great! I cant zoom in enough what size are those Pro’s?

 

295/70/18

 

Skid plate is rubbing on passenger side at full lock, will be bending/trimming

 

Sharp looking truck

 

That's a bummer. Which skid do you have?

 

I believe it is the stock one, bent it up, now barely rubs and I am thinking the alignment will help on Tuesday

 

Damn that looks good! Are you rubbing the front liner?

 

Liner is still out but looks like theres tons of room to re install. Suddenly today I was rubbing at full lock on the skid plate/passenger side but I bent it up and now just barely rubs, alignment might help too. I rear ended someone today, fairly minor damage

 

Damn I hope it’s not bad.

 

Well my claim $ is going to pay for some zone uac's, not digging the bit of bump steer and pull to the right. Also having some rock sliders/steps built, minor front end damage will have to wait a bit

 

If I had the dough this bumper.... https://www.addictivedesertdesigns.com/toyota-tundra-winch-front-bumper-F741202860103

 

Did you swap over factory tpms?

 

Yes I did, plan on listing all my mods soon, but waiting until I finish some things

 

Decided to design the rock sliders from scratch. Only going to have 4 bolt locations I think, so will be more of a glorified step than a slider. Figure I can add bolts at a later date if i feel like drilling the frame for actual offroad capabilities. Already love the look without the hideous stock steps

 

Working out profile/ heights/ length etc

 

Looking good