1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Will 295/55/20 on 20x9 +14 Offset wheels fit on stock 2019 CM SR5??

Discussion in 'Wheels & Tires' started by PatentEd, Aug 21, 2019.

  1. Aug 21, 2019 at 8:59 AM
    #1
    PatentEd

    PatentEd [OP] New Member

    Joined:
    Aug 10, 2019
    Member:
    #34395
    Messages:
    4
    Gender:
    Male
    First Name:
    Eddie
    Vehicle:
    2019 Cement Tundra Crewmax SR5 Off-Road
    So I have chance to buy some 20" Ballistic (20x9 / 5x150 / Offset: +14) Wheels with Nitto Trail Grappler 295/55R20 M/T Tires that came off a Tundra for real good deal.

    Except I can't get a reliable sense as to whether this combo will fit my stock 2019 CM SR5 Off-Road. I searched the forum and I suspect it will be real close, and I may need to take off mud flaps. My truck is leased, so I'm trying not to spend too much. Any opinions, feedback and/or suggestions would be greatly appreciated.

    Best,

    Ed

    WHEELS:
    20" Ballistic 810 Wizard Off-Road Wheels
    Satin Black and Machined Accents
    20x9 / 5x150 / Offset: +14

    TIRES:
    Nitto Trial Grappler M/T
    295/55R20
    Tires have over 50% tread and includes M&B.
     
  2. Aug 21, 2019 at 2:36 PM
    #2
    PatentEd

    PatentEd [OP] New Member

    Joined:
    Aug 10, 2019
    Member:
    #34395
    Messages:
    4
    Gender:
    Male
    First Name:
    Eddie
    Vehicle:
    2019 Cement Tundra Crewmax SR5 Off-Road
    I read somewhere that a 295 55 20 tire (8/10" taller and 8/10" wider than a 275 55 20) on a 20x9 +50mm offset wheel will fit:

    on a 3rd gen with no lift (minor trimming, remove little front mud flaps)
    on a 3rd gen with 1.57" lift (no trimming, remove little front mud flaps)


    I'm just trying to figure out if the +14 offset on the wheels increase or decrease rubbing potential.

    Thanks in advance!
     

Products Discussed in

To Top