1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

wheel spacers and rear blocks

Discussion in 'Wheels & Tires' started by ausei, Jan 19, 2015.

  1. Jan 19, 2015 at 8:49 AM
    #1
    ausei

    ausei [OP] New Member

    Joined:
    Jan 19, 2015
    Member:
    #891
    Messages:
    193
    Gender:
    Male
    First Name:
    Ause
    Baton Rouge, LA
    Vehicle:
    2011 Spruce Tundra TRD SR5 2WD
    3" Leveling Kit 3.5" Spindle Lift 4" Rear Blocks AirAid Intake 20" XD Monsters w/ Nitto Grapplers 1" wheel spacers for rear Magnaflow Exhaust Pro Comp Shocks for rear
    i am about to put a 3.5" spindle lift in addition to my 3" leveling kit. having a hard time finding wheel spacers because the spindle lift will offset the wheels one inch on each side. also looking for some cheap blocks to make the rear sit level. the kit comes with 2" just not sure if its going to balance out. any advice?
     
  2. Jan 23, 2015 at 11:09 PM
    #2
    csuviper

    csuviper Moderator Staff Member

    Joined:
    Jan 6, 2014
    Member:
    #38
    Messages:
    8,858
    Gender:
    Male
    First Name:
    Brian
    Broomfield, CO
    Vehicle:
    2012 Rock Warrior 5.7L 4X4
    Some Mods :) See build thread for details
    I assume you have a 2WD because of the stacking of lifts. This would kill front CVs in a 4WD.
    A good brand of wheel spacers is spidertrax.com. I have them on my truck, 1.25".
    2" might be close but I'm guessing you will prob need around 2.5" -3". Look at the change in shackles. There are several guys that went that route, I almost did. Might have to do a 1" block with the extended shackles. The fabricator could tell you. Hopefully some one will chime in on the mfg???
     
To Top