What have you done to your 2.5 gen Tundra today?

*300k

 

Tried this product on my Tundra letters and top of the bumper. Easy to apply. Noticed quite a difference right away. See how long it lasts.

 

Yep swear by that stuff. Its legit.

 

and counting......

 

I put a molle panel in my console. I put a few things on it to try it out. I’m planning on putting a holster on it maybe this weekend.

 

Replaced OEM engine air filter by K&N. Rev speed is slightly quicker now. No scientific proof LOL. But I am happy with that. I hope it would extend range in the coming road trip.

 

Just don't get it on the paint.

 

Took me a minute to figure out what that was on the lid LOL.

 

The stick with a marshmallow on the end pen? Got it as a gift for camping.

 

Yes....

 

Not sure how long it last, but I agree… it makes a heck of a difference in the appearance of any of that black plastic. Thinking about doing all the plastics on my Club Car golf cart… wish it was kit so expensive.

 

Lowes carries it. It's like $11.00 or so.

 

At least here on my previous wrangler it lasted a year.

 

I also installed the other molle panel on the outside of the console. I like the driver side. But not the passenger side. It don’t look good. I’m not sure what I’m gonna do with it yet. I might modify it.

 

Used the headlight kit on my GF’s daughter’s car and they turned out better than I expected.

 

That looks fantastic on the bumper! Have you tried door handles yet? My 2019's black plastic handles are already pretty faded, I wonder how well they'd clean up.

 

This is on my list, along with the bed side molle they offer. It almost looks like they sent you the passenger side for a 4 Runner.

 

My bumpers look like that also… and yes it works very similar on the door handles.

 

Both panels are the same. Look on their website. Even for the newer tundras, they have the same for both sides. IMO it looks like shit on the passenger side. They need to make the passenger side a little different to look right.

 

Hmmm well maybe next year. I dont really want to have to run premium all the time though. Up in Canada thats about $6 per gallon haha.

 

Well I'm sold. Just ordered some off Amazon.

 

Same.

 

Note to self, don't keep DEET bug spray in the cup holders within the door panel:




Apparently it tipped over and leaked, found its way down to the Door Seal protector and melted it... door panel and everything else seems to be ok, just that foot seal damaged...

 

Things like that amaze me....kind of like coffee creamer.....it will stain concrete.

 

Yea, it eats away at the clear coat too.... can see some of the streaks that ran down if I look close enough..

 

For sure, makes you think twice about spraying that on now or drinking creamer haha.

 

greased the drive shaft U joints and tie rods. They were DRY. Hope I didn't cause too much damage through ignorance.

 

Plugged in my non-JBL amp bypass harness.
Harness

tucked nice an neat under the oem parts

 

Did it make a big difference?