1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Removing one CB shim on 6112

Discussion in 'Suspension' started by Jalzate44, Oct 17, 2020.

  1. Oct 17, 2020 at 4:39 PM
    #1
    Jalzate44

    Jalzate44 [OP] New Member

    Joined:
    May 24, 2020
    Member:
    #47042
    Messages:
    134
    Gender:
    Male
    First Name:
    John
    San Anotnio TX
    Vehicle:
    2015 MGM Tundra SR5 DC
    Hello,
    How difficult is it to remove just one CB shim from an already installed 6112 setup
     
  2. Oct 17, 2020 at 4:44 PM
    #2
    Kanobi13

    Kanobi13 New Member

    Joined:
    Mar 27, 2018
    Member:
    #13944
    Messages:
    401
    Gender:
    Male
    Same process as adding it
     
    toyofan87 likes this.
  3. Oct 17, 2020 at 4:47 PM
    #3
    Jalzate44

    Jalzate44 [OP] New Member

    Joined:
    May 24, 2020
    Member:
    #47042
    Messages:
    134
    Gender:
    Male
    First Name:
    John
    San Anotnio TX
    Vehicle:
    2015 MGM Tundra SR5 DC
    I had 4WP install them but now I have added weight to the rear and it sits nose high. Wanted to see if it was easy enough to do myself
     
  4. Oct 17, 2020 at 4:53 PM
    #4
    Kanobi13

    Kanobi13 New Member

    Joined:
    Mar 27, 2018
    Member:
    #13944
    Messages:
    401
    Gender:
    Male
    Def do it yourself take top bolts bottom bolt out of coil over. i doubt you would need to take anything else off since you are not lifting. Might need a pry bar to get out going in should slip right. If that does not work pull bolts from lower control arm loosen front bolts on cam and swing out of the way. Make sure to mark cams. Remove shim re install take to get aligned.

    Edit: remove sway bar bolts while on the ground first.
     

Products Discussed in

To Top