Pay it forward----> free goodies.

Good research! You’re on top of it. You deserve them

 

Ah, I just saw that in his original post. I was only looking at what was listed in the profile lol. Just ignore me.

 

Where does safety fall on the mod list?..

 

It doesn't. Cut those supports. Hand tighten all the things. Use wire nuts to your heart's content.

 

Haha, no I appreciate it because I didn't notice the 2021 in his profile. Better safe than sorry!

 

The good ole days..
Starter solenoid?

 

The other stuff.

1. Toyota Entune Amp Upgrade for Tundra and Tacoma (autoharnesshouse.com)
TAKEN

2. Two climate control knobs from a 2014 Tundra SR5
I can give these away together or independently upon one's needs
If you only need one, only take one.


3. 3 AC dash vent trim rings.
Why 3?
I have no idea.
Again, I can give these away together or independently upon one's needs
If you only need one, only take one.



4. Silver shift gate trim
It's in pretty good shape.
You can see I did have to melt some plastic welds to remove it.
Perfect if you wanted to try to paint one without ruining your own OEM part.



5. Chrome trim ring for the cup holders
This is a bit beat up and one of the tabs is broken.
Again, perfect if you want to try to paint one without ruining your own OEM part.



Post on this thread by number 'I'll take it' and shoot me a PM with your NAME and shipping address.
That will avoid confusion if it is taken or not.
I'll cover shipping.

If no one wants this stuff within a week it goes in the trash.
I replaced most of this with AJT parts.

Thanks...
1lowlife.

 

If it is still available, I will take the console charger.

My old man needs a charger.

 

It's yours @biebs96
I think I deleted the PM with your address.
Send me your name and address again and I'll get it out in a few days..

 

I'd love the harness (#1) if it hasn't been spoken for. Let me know what you want for shipping. Thanks!

 

I'll get it out in a few days, I just got home from oral surgery.
I'll cover shipping.

 

Item TAKEN.


The OEM phone charger is back up.
Fits 2014 to 2021 consoles.

It has a little wear and you'll need to retain your console badge and put it on this one.
I ended up swapping it for a Magsafe charger.

Post 'I'll take it' here and send me your name and shipping address.
I'll cover shipping..



OEM instructions
Microsoft Word - DRAFT - 2019 TUNDRA Wireless Charger Tray WI v2 (1).docx (d354nuoz4t18d4.cloudfront.net)


I used this video to install and them swap it out..
https://youtu.be/8m11ze1vzs4

 

I'll take it.

 

PM responded..

 

2nd in line if it's still available.

 

It is going out to @Pillslinger this weekend..

 

I have a set of tube steps that are getting ready to go to scrap, nothing wrong with them I just put running board type on. Must come to me at the Home Depot in Dahlonega, GA

 

SOLD
I ordered the wrong switch panel from @RainMan_PNW

It's the 3 switch V.2 for SR5 trucks.

Free pickup around Splendora, Texas. Or just pay shipping.

 

PMed.

 

Sorry about the mix up.

and yes - I asked him to post it up in here for someone else to grab.

 

Found these in storage. Two sets of front row OEM carpet floor mats. Fits 14-21. Pickup in Justin, TX 76247 by Texas motor speedway. If you're local I'm all over the metroplex for work so I don't mind meeting up if it doesn't affect my schedule. One is the TRD Pro mats and the other is the standard tundra mats. Will ship if you pay for it.

 

Just replaced my OEM rotors off my 2019. Before I give them to recycling bin at my work offering free to anyone in San Diego area. They have approximately 58,000 miles on them.

 

Does anyone know if these will fit a 2nd gen?

 

don't quote me, but i'm about 99% sure they wont

 

Don't tell me what to do.

 

The fronts should be close... I can check with my Dad's 21' later today if you want to know for sure

 

I'd appreciate it, if it's not too much trouble.