1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

New Belt & water pump

Discussion in '1st Gen Tundras (2000-2006)' started by Scarecrow, Apr 2, 2016.

  1. Apr 2, 2016 at 8:05 AM
    #1
    Scarecrow

    Scarecrow [OP] New Member

    Joined:
    Feb 20, 2016
    Member:
    #2730
    Messages:
    134
    Gender:
    Male
    First Name:
    Zack
    Vehicle:
    06 Tundra SR5 4.7 v8 4x4
    Just got the new belt and pump installed yesterday along with a new thermostat. Is there anything I should be mindful of for a couple miles like a break in period or anything where I should not push this too hard? Im rather glad I got it all done I looked at the belt it looked good still no cracks or cuts but the water pump did look like it was starting to leak. Glad I got it done no more need to worry about that.
     
    NewImprovedRon likes this.
  2. Apr 2, 2016 at 8:54 AM
    #2
    LOTSOFTOYS

    LOTSOFTOYS Toyota Whisperer

    Joined:
    Jun 9, 2015
    Member:
    #1396
    Messages:
    1,246
    Gender:
    Male
    First Name:
    Jace
    Mile high
    Vehicle:
    2005 Tundra DBL cab
    Nope, drive the piss out of it;) monitor your coolant level, it may burp some air out over the next few days
     
    NewImprovedRon likes this.

Products Discussed in

To Top