1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

My 03 build

Discussion in '1st Gen Builds (2000-2006)' started by Brown Bear, Sep 7, 2017.

  1. May 26, 2021 at 6:07 PM
    #91
    Brown Bear

    Brown Bear [OP] New Member

    Joined:
    Aug 31, 2017
    Member:
    #9374
    Messages:
    434
    Gender:
    Male
    Nor cal
    Vehicle:
    03 TRD offroad
    -6" RCD lift in front. -Custom leaf springs in rear 4" lift. -17" race line, raptor wheels. -35" Goodyear Duratrac. -4.88 gears. -ARB rear air locker. -ARB air compressor and tank. -Custom front sway bar quick disconnect -Custom one piece driveshaft -Black Oak Led 40 watt ditch lights.
    I did have a small amount of rubbing on the rear of the front fender. But that was only in full flex and when the tires were brand new. I did have to take off the front mud flaps. When I get new tiers I might take a heat gun to the plastic and try to tap it in a little bit.
     
  2. Nov 2, 2021 at 4:13 PM
    #92
    0h6SR5

    0h6SR5 New Member

    Joined:
    Oct 22, 2021
    Member:
    #69709
    Messages:
    76
    Gender:
    Male
    Vehicle:
    2006 Phantom Grey Tundra
    3 inch OME with AAL wheels and tires. 285 70 17
    are you by any chance thinking of building and selling these?
     
    Voss likes this.
  3. Mar 15, 2022 at 9:16 AM
    #93
    vahevar

    vahevar New Member

    Joined:
    Mar 13, 2022
    Member:
    #75794
    Messages:
    2
    Gender:
    Male

    Hi I was looking at your post regarding the quick disconnect and I want to make one for my sequoia. however the link below is not working. Can you please point me to the right direction.

    4- 5/8 x 1/2 Misalignment Spacer
    https://www.ruffstuffspecialties.co...Product_Code=58TO12SS&Category_Code=58REPARTS

    also for the pins I feel like they will come out on their own. Can I use something like this?

    https://www.grainger.com/product/GRAINGER-APPROVED-Quick-Release-Pin-410K88
     
  4. Mar 17, 2022 at 6:52 AM
    #94
    vahevar

    vahevar New Member

    Joined:
    Mar 13, 2022
    Member:
    #75794
    Messages:
    2
    Gender:
    Male
    can you please post the link to the video
     

Products Discussed in

To Top