1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

LED rear bumper tail/brake lights reflector swap

Discussion in 'Sequoia Builds' started by farnsrocket, Aug 20, 2023.

  1. Aug 20, 2023 at 3:09 AM
    #1
    farnsrocket

    farnsrocket [OP] New Member

    Joined:
    Feb 14, 2021
    Member:
    #59103
    Messages:
    331
    Gender:
    Male
    Got these to replace my rear bumper reflectors.
    https://a.co/d/5XSBheM

    I followed this video:
    https://youtu.be/IoBaeBN6jL8

    They are identical to the OEM reflectors as far as having a single bolt to mount them. You could reuse the OEM nut and washer but were a little rusty so I upgraded to a stainless steel lock nut and fender washer. The wire is long enough to reach up to the tail light and I spliced it directly into the tail light wiring......Red to Red, White to Green and Black to White wire w/ black stripe.
    I also sealed up where the wires come out of the reflector with some E6000 adhesive to make them waterproof.
    They turn on with the parking lights and get brighter with the brake lights. I was very impressed with their brightness and operation for $20!

    [​IMG]


    Video:

    https://i.imgur.com/7wbgXNl.mp4
    [​IMG]
     
    Last edited: Aug 20, 2023
    Bama and donellyd like this.

Products Discussed in

To Top