1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Front grill

Discussion in '2nd Gen Tundras (2007-2013)' started by Buddy, Jun 5, 2017.

  1. Jun 5, 2017 at 2:22 PM
    #1
    Buddy

    Buddy [OP] New Member

    Joined:
    May 20, 2017
    Member:
    #7783
    Messages:
    5
    Gender:
    Male
    First Name:
    Mike
    Vehicle:
    2008 light blue
    6 inch lift 35 tires Exhaust
    Question
    Have a 2008 Tundra wanting to plastic dip my front grill
    I go to remove the nuts from the engine bay side and they all spin
    Any tricks getting them out? Or just mask the truck up and paint
    Thanks
     
  2. Jun 5, 2017 at 3:59 PM
    #2
    Eclipsed & Floating

    Eclipsed & Floating Over it.........

    Joined:
    Feb 20, 2017
    Member:
    #6454
    Messages:
    12,527
    Gender:
    Male
    I’m right where I need to be
    Vehicle:
    Voluptuous Whitey
    Dip away. You can always peel what you don't want off the areas you don't want it. Make sure it's clean or it can be sticky. Also if it's dirty you can have excess peeling where you don't want peeling
     

Products Discussed in

To Top