1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

FAb Fours rear bumper, BSM Sensor issue

Discussion in '2.5 Gen Tundras (2014-2021)' started by epwildcat, Jan 14, 2018.

  1. Jan 14, 2018 at 2:58 PM
    #1
    epwildcat

    epwildcat [OP] New Member

    Joined:
    Nov 6, 2017
    Member:
    #10802
    Messages:
    4
    Gender:
    Male
    I recently installed a premium fab fours steel bumper on my 16’ tundra. I knew that my blind spot monitoring would not work with this bumper, but after installing it the side mirrors sensor is constantly ON. Even if I have the selector “off” on the dash, they still stay glowing on the mirrors. Do I need to hook the sensor plates back up to solve this issue or what?
     
  2. Jan 14, 2018 at 3:38 PM
    #2
    Cuzican

    Cuzican New Member

    Joined:
    Jul 14, 2017
    Member:
    #8556
    Messages:
    692
    Gender:
    Male
    First Name:
    Chris
    Louisiana
    Vehicle:
    2017 Black Platinum Crewmax Tundra
    8" Lift, 22x10 Fuel Forged FF19, 37x13.50r22 Trail Grapplers, Amp Research steps, Spyder black smoked headlights with 35w HID's, all interior lights LED, Undercover tonneau.
    I would say yes, because even turned off the truck still sees an open circuit that it is reading as a bad sensor.
     

Products Discussed in

To Top