Chuck 2014 DC build.

Long overdue on getting on the forum and getting this thread up and running.
I’ve had this sr5 double cab for almost 10 years and am finally doing some overhauling.
I’ve actually already done my HU for a Kenwood 1037 (thanks everyone on here for the info on that). I put some decked drawers in the bed and found a cheap ARE cover to throw over the top to hide em a little.
Next up is a new bumper, followed by a lift installed by yours truly. Anyways, here’s a couple pics.

 

Bumper is on!

 

Only one “issue”. Trying to find a way to route a this cable for the light switch. Little bigger than the cable for my front camera. Is drilling the firewall the best way?

 

Truck is off to a good start, love the rock warrior wheels you got on there. Normally there is a rubber grummet you can cut into and runs wires from inside the cab to the bay. I would look for one along the firewall by the booster. Might see if you could de-pin the clip to make it smaller and easier to fit through.

 

Thank you! I got lucky with the rock warriors locally a few years back! After I read about them on here of course!

Got the wire through. Little more force and the coat hanger got it all the way past it. Happy to report the lights work! Not disappointed at all with the lights and bumper set up!

Another local score!