Awful grinding sound in reverse

If i use chalk i might get distracted and forget what i'm doing.

I'll probably work on that tomorrow when the sun is out...if it is. DAMN SNOW

 

A little bit. But if you try this, be sure to record it for us.

 

Why not get a volunteer to ride underneath to maybe see/hear what's causing the issue? First hand observation is always best....... (not me of course... hmmm. enough beer?? no)

 

Maybe @Sean266 can go ahead and set me up with a sticky so nobody else has to try it

 

chicken

 

Where the heck is Sean and Brian? Goofing off this weekend no doubt.

 

Depends on the trail you take.

 

@Sean266 i was referring to this post as the DIY

 

Sheesh... How much is gas going for up there in Alma? Just sayin...if I'm in the area by some coincidence....

 

There is no gas in Alma. It's Fairplay or Breckenfridge....and it's about 15 cents higher than down there.

 

This

 

@Bear and @joonbug were right.

More plastic than cab mount but there's some rubbing on it too. Only about a half inch on drivers side. That's at full lock so I'm not going to worry about that for now but the plastics will be fixed sooner than later

Thanks fellas for helping me work through the possibilities and a special to @Backslider for the schooling on alignments.

This forum is awesome in so many ways, even more than you guys know. It helps me keep my mind off the tragedy that my ex has created and has taught me many a lesson in just a few months. Thanks for the support. You guys are my bros and most of you I've yet to meet!

 

Been there done that bud. Both with the rubbing shit on the fenders (still does it at full lock, reverse only), and the "other" shit as well from what can only be described as an indescribably wasted space of a human being. Ah well...live and learn bud. Live and learn