1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Air injection valve wiring harness or connector

Discussion in '2nd Gen Tundras (2007-2013)' started by Limabean70, Feb 23, 2020.

  1. Feb 23, 2020 at 6:41 PM
    #1
    Limabean70

    Limabean70 [OP] New Member

    Joined:
    Feb 23, 2020
    Member:
    #43062
    Messages:
    1
    Gender:
    Male
    2008 Tundra 4.7 L. Having terrible time getting the emissions codes to go away. Have replaced both injection valves and pumps. Truck was code free for about 2 months when P2437 put truck in limp mode again. Everything is new but wiring harness. Would replacing this fix the problem and where can I find this part? I have looked at multiple sites but it’s not listed anywhere. The Hewitt site had something called the air pressure sensor harness that looked like it. Please help!
     
  2. Feb 24, 2020 at 9:04 AM
    #2
    parker44

    parker44 New Member

    Joined:
    Feb 6, 2018
    Member:
    #12700
    Messages:
    588
    Gender:
    Male
    Vehicle:
    2008 Tundra - Desert Sand Mica
    Contact Hewitt Technologies. They are active on the forum as well, but probably quicker to just call them up.
     

Products Discussed in

To Top