2019 TRD Pro headlights with upgraded LED turn signals

Installed some Sylvania zenvos and it resolved the issue.

 

Good to hear.

 

If you go directly to GTR website, its cheaper to get the 7440/7443 compared to Headlight Revolution.
https://gtrlighting.com/gtr-lighting-armor-series-7440-7443-led-bulbs/
https://headlightrevolution.com/gtr-lighting-armor-series-7440-7443-led-bulbs/
Well, Ill take it back. Lol, abot less than $10 less with S&H.

 

I installed the iBrights stars leds. From interior to the exterior even the rear turn signals. I didn’t use any resistor. Everything works fine. I’m planning on doing the front turn signals soon. Do I need a resistor?

 

Probably. Try LEDs in the fronts and see what happens.

If you have hyperflash after installing LEDs in the fronts, I would install the resisters behind the rear tail lights since it doesn't matter where in the circuit the resister is installed. Mount them to the steel bulkhead behind the tail lights to avoid them overheating and melting anything. If you didn't have hyperflash with only the rears converted, then you'll need one 6ohm/50watt resister on each side.

 

Thanks for the tip. It should arrive tomorrow. I’ll let you know what happens. Fingers crossed

 

Question: I upgraded and installed the TRD Pro LED headlights and want to upgrade the front turn signal bulbs to LEDs (I already did the rear turn signals with a resistor). Will this four pack fit both the side marker and turn signal bulbs?

 

Without checking, I'm fairly certain the side marker is smaller with a different number.

 

I ordered the

$19 Antline 7443 7440 T20 7440NA 992 W21W 7444 21-SMD 2835 Chipsets 1260 Lumens LED Bulb Replacement Amber Yellow for Car Turn Signal Blinker Side Marker Lights Bulbs (Pack of 4)

Antline 7443 bulbs for the front turn signals. I previously ordered several LED bulbs from Headlight Revolution to upgrade the rear tail lights, etc. - way overpriced and won’t make that same mistake again for what you get.

 

Just installed the Antline bulbs - what a difference. Easy 5 min install too, didn't have to remove the headlight assemblies!

 

This would be alot easier and attractive to purchase if everything was baked in. Seems as if the taillights are, but should have LED cargo included, headlights should be all LED or nothing. Still running halogens in my 16. No hyperflash or resistors heating up, etc. The headlights suck but what a tightrope to walk. Manufacturers need to streamline this.

 

It is quite odd that a great LED headlight like the TRD Pro version still has a crappy incandescent turn signal bulb..go figure