2006 Double cab Leds CANbus yes or no

Upgrading some of the bulbs to LEDs. No headlights or blinkers.

I've glanced around and can't seem to find a DEFINITE answer if I need CANbus LEDs or non-CANbus LEDs.

3 places say I have CANbus:
http://www.auterraweb.com/aboutcan.html

http://scantoolcenter.com/obd2-basic/which-obd-2-protocol-is-supported-by-your-vehicle/

http://www.obdii.com/connector.html

I have these pins in my DLC:
4 Chassis ground
5 Signal ground
6 CANH
7 SIL
11 Airbag
12 TS
13 TC
14 CANL
15 WHSE
16 B+

When I turn the ignition key to ON, the only lights lit during the "light test" mode are:
Tire
Airbag
Check engine
Seatbelt
ABS
Maint reqd
Battery

I'm guessing since I have no true Driver Information Center, nor any indicators that I have a "bulb out" that I can use non-CANbus LEDs.

Thanks in advance...........

I added this info for the next poor soul who may be looking for this answer.

 

I post my question on March 30th.
Finally got a response.
What the ? ! ? ! ?
SPAM

 

Did you ever get an answer to this question? I have the same question before I buy reverse tail/ brake and front and rear turn signals?

 

Bumping old thread,
Are these older tundras CANBUS or not?

 

No CANBUS issues with LED's in Dash, ceiling, reverse, DRL, or door lighting on my '05 double cab.