1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2001 tundra sensor 1 bank 1 code p0135

Discussion in '1st Gen Tundras (2000-2006)' started by Jminuni, Mar 23, 2020.

  1. Mar 23, 2020 at 2:27 PM
    #1
    Jminuni

    Jminuni [OP] New Member

    Joined:
    Feb 9, 2020
    Member:
    #42400
    Messages:
    5
    Gender:
    Male
    First Name:
    Josh
    Vehicle:
    2001 blue tundra access cab
    I have a 2001 4.7l and I had a CEL code for the bank 1 sensor 1 since I bought the truck In December. I just replaced the o2 sensor and 3 days later the code finally went off. 2 days of driving now and it just came back on. What is the cause of this could it just show up and it will go away again or is their something else wrong?
     
  2. Mar 23, 2020 at 3:05 PM
    #2
    docfnky

    docfnky New Member

    Joined:
    Mar 12, 2020
    Member:
    #43869
    Messages:
    10
    Gender:
    Male
    Did you use a high quality sensor? Denso or similar. Did you replace the right one? Driver side on the manifold?
     
  3. Mar 23, 2020 at 4:05 PM
    #3
    Jminuni

    Jminuni [OP] New Member

    Joined:
    Feb 9, 2020
    Member:
    #42400
    Messages:
    5
    Gender:
    Male
    First Name:
    Josh
    Vehicle:
    2001 blue tundra access cab
    Yes I used a denso and it was the drivers side
     
  4. Mar 23, 2020 at 4:47 PM
    #4
    PCJ

    PCJ New Member

    Joined:
    Sep 3, 2019
    Member:
    #35549
    Messages:
    186
    Gender:
    Male
    State of Jefferson
    Vehicle:
    2004 DC Limited 4X4
    Lift, Rims, Bigger Tires, Nerf Bars, Black Out Emblems
    Where did you get it? Are you positive it's not counterfeit? I generally change both upstream and downstream together.
     
  5. Mar 23, 2020 at 4:50 PM
    #5
    Jminuni

    Jminuni [OP] New Member

    Joined:
    Feb 9, 2020
    Member:
    #42400
    Messages:
    5
    Gender:
    Male
    First Name:
    Josh
    Vehicle:
    2001 blue tundra access cab
  6. Mar 24, 2020 at 9:31 AM
    #6
    docfnky

    docfnky New Member

    Joined:
    Mar 12, 2020
    Member:
    #43869
    Messages:
    10
    Gender:
    Male
    Trace the wiring to see if there’s a cut or short somewhere. You can also take a look at the MAF sensor and try to clean that. If the replacement sensor is good then the original problem still exist and it’s likely an air/fuel mixture issue. Clean the MAF, the idle air control valve and EGR while you’re at it.
     

Products Discussed in

To Top