1st Gen. Lunch Table - General Discussion

I did get the fender away from the door. I'm going to update my build thread with all of these photos instead of dropping them here. I'll post there in a bit.

 

I noticed my driver bellow is totally screwed today when I went to put it back on with a metal zip tie. I had used plastic zip ties when me and Casey changed the tie rods, and the driver side below kept coming off the rack. It's pretty shredded now.
I'm assuming brand isn't a big deal for a part like this. I figure I'll order a new one tonight. Going to check AutoZone website and rock auto.

These universal bellows from SPC look cool. Not sure if they actually fit though.
https://www.oreillyauto.com/detail/.../automotive-truck-2006-toyota-tundra?q=Bellow

After shipping, a single Beck Arnley bellow from rockauto come out to within a dollar of AutoZone.

 

I used a cheap-O bellow from RA. Shredded itself in a year or so. Detroit axle bellow on there now. Will inspect tomorrow. Still one OEM bellow (26yrs old) that looks minty.

 

Did you order the BT-673x2 or BT-637x2?
They are only 44¢ difference in price, but the dimensions are different. One is 8x6x2 inch and the other is 9x3x7 inch. Both are listed for my truck, though.
I like that I can get a pair of these for a better price than anywhere else. And they have a ten year warranty.