285/70/18’s rubbing on off ramps?

I cannot tell where? Traction control started beeping and I cannot see where it would rub? Thanks. D

 

Just because TC went off doesn't mean it's rubbing.

 

Is your front end lifted at all?

 

Going 40 on off ramps. Toytec Boss 3” lift. No signs of run makes. Ridge Grapplers. Thanks. D

 

Find some sidewalk chalk and color it all in...you can very clearly see where it rubs they just wipe it off.

 

You sure it isn’t just TC? It sounds like hell.

 

Are all 4 tires worn equaly?

 

Did you do a zero point calibration after your lift?

 

You need a zero point calibration, and if it's rubbing , it may be the trd off-road skid plate.

 

I have brand new tires and rims. 25+offset. As soon as I installed Toytec Boss I had front end alignment at Toyota. Peace. D

 

Don't forget to check both front and back of wheel well, including the cab mount

 

I have some problem when making turns above 35 to 40 mph

 

I did the point zero calibration and also lifted the vsc module with some washers to trick computer that truck has a rake and seemed to have helped

 

Just did right turn off ramp again today with traction control off. Seems more like a computer electronic alert sound than any rubbing sound or could be both? My trd sway bar in back. When I reenstalled it after adding shackles. Is there any way to tighten moving joint too much? Because I really cranked her down. Came with truck so I do not have install directions. Can I do the zero point calibration myself or does a shop have to do it? Thanks for all the help. Peace. D

 

I work at dealer so hard them do it.......also did the vsc module lift