1st Gen. Lunch Table - General Discussion

Is Continental Elite the serpentine belt that used to be the Gatorback belt or does anyone have anything horrible to say about it? (Puck excluded).

 

I only went to Decatur because that was the one you listed in the ad. I'll check Birmingham for sure.

 

10-4. It sounds like a Toyota corporate sale so you can probably pick from your favorite dealer list.

 

Is the plastic drop-in bedliner secured or mounted in any way? Or does it just sit there and tuck under the bed rails?

Planning on pulling it out soon and cleaning underneath it.

 

Is there a ninth injector in there? Also missing a turbo, I only see one. A sequential setup would be cool.

 

Mine is just sitting in there, under the bed rails

 

My list is a little out of order, but here's what's in my cart. Other than a THIS, what might I be missing?

VALVE COVER GASKETS & TIMING BELT JOB

Spark Plugs - 90919-01192 (x 6)

Spark Plug Wires - 19037-62010 (1 Set)

Throttle Body Gasket (Not for Supercharged engines) 22271-62040

Intake Plenum Gaskets - 17176-62040 (x 2)

Valve Cover Gaskets - 11213-62020 (x 2)

PCV Valve - 12204-62010

PCV Grommet - 90480-18001

Semicircular Plugs - 11183-62010 (x 4)

Valve Cover Bolt Washers - 90210-05007 (x 16)

Camshaft Plugs - 11188-62010 (x 4)

Toyota FIPG - 00295-00103

Spark Plug Tube Seals - 11193-70010 (x 6)

REAR MAIN SEAL - 90311-38051

Thermostat- 90916-03075

Thermostat Gasket - 16325-62010

Power Steering Belt- 99364-81070

Alternator Belt- 90080-91090

A/C Belt- 99364-20870-78

Timing Belt 13568-YZZ03

Tensioner 13540-62021

Water Pump 16100-69398-83

Camshaft Seal - 90311-40022 (x4)

Oil Pump Front Main Seal - 90311-40022

 

Dang. You pulling the motor or dropping the transmission?

 

Drop trans should be the easier route

 

You covered your ass with this. Smart.

 

Ever seen a 4" straight pipe for some sort of diesel on cl for $25 & decide you needed it?

 

Through bed exhaust snorkel

 

its not perfect, but i could make it work.

 

Why aren’t our automotive air conditioners powered this way

 

Cats and resonator delete? Perhaps single exit straight pipes? Gonna need some headers to really complete my vision haha.
I'm thinking LT headers, no cats, 3 inch intermediate pipes going to a Y with a 4 inch pipe out, no muffler, just a resonator, dumped after the rear axle.

 

Nascar dustpan exhaust tips.

 

for a sense of scale:

 

That’s gonna mess with your back-pressure, er flux capacitation uh inline rotary gutter specs.

 

Send it

 

What discount code are you using? @bfunke posted this one a little bit ago. Still active 257187659198834985

 

So before I place my order for WL calipers, rotors and pads, do the WL calipers use the same caliper bracket as the WE?

 

yes

 

Pretty sure they use the same rotors.

 

I'm replacing rotors anyway since these are warped again after 8 years.

 

I think I finally found the wheels I’m gonna get


It’s either those or the rocktrix rt112 in bronze. Just cause it would cost me like $150 less

 

How does everyone warp rotors? Are you too close to the vehicles in front of you? Get surprised by obstacles? Tow a trailer like you stole it? Maybe towing a TT down a mountain pass being chased by a passive aggressive roadrager?



the tundra has better engine braking than the 5.6 in the titan.

 

I also wonder this