35x12.50r20 Pictures on 3 inch lift

he was going to post a pic yesterday or today wasn't he ?

 

Oh yeah they do. Been trying to take a pic today, but got busy at work. So what’s up with the jackass tech? Obviously I don’t know what I’m reading, but he didn’t do his job?

 

Time to go complain!

 

I’m gonna try to get to firestone bright and early... I need to know if the dude is just an asshat, or if there is no adjustment in my camber. Is it supposed to be at 0*?

 

I bought the lifetime one. Got it done at 1,845 miles. I’m at 7,200 now.

 

this is a complete PITA !!

 

What lift you running? I'm leaning toward the bds but the tire wear issue has me thinking I might go the ready lift route

 

I just posted in a new topic about the 4" readylift kit. Im looking to maybe go that route and would like to see some pictures and feedback

 

Specs on your wheels, I dig your setup

 

Do you have a link? I didn't see it, thanks

 

if you click on newest post at the top of the page its then about half way down. Just posted it so no responses yet but hope there will be some soon

 

Gotcha, we will probly get flamed for asking about a spacer lift but the mall isn't going to crawl itself. I downloaded the install manual and didn't see anything about cutting the xmember also. Plus if you decide to go bigger down the road it only costs 400 bucks

 

you don't cut with that kit.

 

I have a 3/1 kit now so its a spacer lift with a shackle in the rear and I don't have any problems with it except the alignment with the stock arms so need to do something soon either go with the 4" or get aftermarket UCA's for the current setup

 

Awesome look. I like the flag too ... nice touch. I might have to look into that.

 

thats me! man I wish you lived closer lol

 

That's what I thought, but i read on another forum you need to trim 30% off the x member. Maybe that's on 2nd gen or an older design though.

 

I watch a few install videos on the BDS, you chop that puppy completely off. The kit even included caps to weld over the holes once its gone

 

4.5 bds, the 6 and 8in RL don't show any cutting though. Ive lifted a quite few ifs rigs and had to cut all of them over 4 inches. I'm not sure how RL gets away with not cutting

 

That’s the one I’m thinking about getting

 

I posted a new thread hoping to see some tundras with that kit installed

 

Yeah but you only get 3” on that correct ? Or tops 3.5” ?

 

Incredibly helpful. I’ll let you know if I make it over there tomorrow. Thanks for all the advice!

 

It’s a Toytec/eibach 3 inch front, toytec shackles at 1 inch and 5100s in rear

Thank you, SCS SR8s 18x9 +25

 

@15Yota here’s the alignment sheet after picking it up just now. Thoughts?

 

They are about spot on. Remind me your lift setup?

 

Who aligned it ?

 

Any pictures of your front tires now after the alignment?

 

Heavens to Betsy. Well I appreciate all the insight, I wouldn’t have gotten it aligned again for awhile if you didn’t say anything. Think I should be alright without UCA’s now?

Firestone aligned it. They aligned it the first time, but I used a different firestone this time. I should have taken a before tires picture... I’ll run outside in a few and try and get a new one.

 

Good lord, I just saw your build thread. That this is a freaking monster.