What have you done to your 2.5 gen Tundra today?

I'm contemplating the same.

 

Oh man....

 

Out with the old, in with the new. Can absolutely tell a difference in airflow

 

hell yea!

 

I did the same... awesome

 

Washed and waxed.

 

Update. Let’s play a game. In the picture attached, is that engine oil or 103k transmission fluid? I’ll give you all a hint, it’s not engine oil. Pulled out about 3.5 quarts. Put in 4 quarts and realized when I got to temp, my check plug is rusted and round so I can’t get it off. Any ideas? Or send it.

 

Spray it down with PB blaster and let it set for a minute. Clamp a set if vice grips on the as tight as you can get them. Use a hammer on the vice grip to break the rust loose. If you have a blow torch, heat around the bolt of course being careful not to start any fires. It may take several applications of each to get it loose.

 

I’m an idiot. It’s a 5mm Allen

 

You can order a replacement that is a hex head

$12 OAUTOO 12pcs Transmission Drain Plug with Gasket Kit for Toyota 90341-10011, 35178-30010 4Runner Corolla, Land Cruiser, RAV4, Sequoia, Tacoma, Tundra, Fits Lexus GS GX is LC LS LX RC SC 1978-On

https://www.amazon.com/dp/B0D14ZMJ33

 

Installed the FRAC harness today. Took longer than expected since i had to extend the wires for the switch and the local home improvement stores don’t carry 20awg wire . So the interior was torn apart for a day while i awaited my Amazon shipment of wire.

 

That’s what I’m going to do. Even after spraying it with pb and letting it soak then using an alley key, it’s rusted and rounded with barely any pressure.

 

You may can get a pair of vise grips on it enough to get it off

 

Did you ever figure this out?

 

Yep just got it off that way. Worked since it wasn’t super tight. Just an awkward angle. Ended up draining about a half quart through it.

 

Yaaaaay!!! I've had the same problem, that's how I know it works!

 

It's the stealth spare tire mount.

 

Nice! I’m definitely doing another DnF soon so I’ll replace that plug then

 

Figure I'm headed this route before end of year. OEM fan bearings are making a bit of noise this past month.

 

Sounds good buddy!!

 

Looked back at it…. Twice

 

Looks great with a red body!

 

For good reason!

 

Didn’t get any pictures but I did the 200ish mile bolt check on all my new suspension components. I felt a little clunk while driving, and it turns out that my UCA bolts need a couple more turns after settling. With everything torqued back down to spec the front end feels super tight, in a good way. Now I just gotta paint mark all the nuts to make it look super extra race truck official.

 

NSB

 

Bought a Tuffy Security Console Safe on Amazon. Easy install and still able to put the organizer on the top side of the console.

$199 Tuffy Security Console Safe - Compatible with Toyota Tundra 2014-Current

https://www.amazon.com/dp/B01GBFF86I