Removing one CB shim on 6112

Hello,
How difficult is it to remove just one CB shim from an already installed 6112 setup

 

Same process as adding it

 

I had 4WP install them but now I have added weight to the rear and it sits nose high. Wanted to see if it was easy enough to do myself

 

Def do it yourself take top bolts bottom bolt out of coil over. i doubt you would need to take anything else off since you are not lifting. Might need a pry bar to get out going in should slip right. If that does not work pull bolts from lower control arm loosen front bolts on cam and swing out of the way. Make sure to mark cams. Remove shim re install take to get aligned.

Edit: remove sway bar bolts while on the ground first.