What have you done to your 2.5 gen Tundra today?

Tried that and no luck but did the tundras.com and that worked

 

anyone know who has the best pricing on BILLSTEINS ?

 

Correct. Sorry. Too many drinks while on mandatory COVID19 separation

 

Not that I know of but cool springs has got free shipping
There’s a thread on that topic as of today. Home page

 

That dif breather does look identical to the ARB. Here's my ARB mounted in the engine bay.

 

Dont forget to get the harness from @iHacker.

 

80 something degrees today so gave her a bath.

 

Damn that looks good. What's the specs on your wheels and tires, offset? What have you done to the suspension?

 

Thank you sir! Wheels are +20 offset, 285/55 R20 BFG KO2’s which came on the truck new with the TSS wheels and swapped them for the fuel Mavericks. Suspension is all stock as of now but hopefully the next thing I am doing soon is 5100’s in the front probably on the middle setting which I think is about 1.6” of lift.

 

My truck had 20" BBS wheels with a +50 offset and 285/55 BFG ko2s, stock suspension. Do you have any rubbing anywhere with the +20 offset? Also, do you have any pics looking down the side of your truck, front to back, so I can see how far they stick out.

 

When i first had them put on they didn’t rub but I after I took it in to the dealer for pulling to the right issues it rubbed in reverse at full crank but just barely and I have since removed all the mud flaps including the ones in front of the front wheels, so plenty of room now. Here is the best pic I have down the side. Pretty nice reflection shot in this one as well lol.

 

That's perfect. Thanks.

 

Try Redline360.com....5100’s are $99.99 which about the lowest I’ve seen. Ordered some tail lights from them and it was a smooth transaction.

 

Thanks ! I will check it out now.

 

They have free shipping ?

 

I think when I created a cart to see what the total would be, I want to say it was $25. But can’t remember if that was for both or each. But they did charge shipping for the tail lights.

 

Thanks again

 

That's odd. If you go back and look, I'm not the one that ask about free shipping. But it shows me, when you quoted the free shipping question. Lol

 

i blame corona

 

(Yesterday) lubed my shaft up real good . Just did the 3 on the rear, I wasn't able to get to the front zerks because of my RCI skids, they were a pita to install by myself in the driveway so I didn't feel like dropping them to do it... Maybe one day if I'm really bored I'll try to get to those. Used the Lucas Oil Red n Tacky stuff until they came out the seals. Some really nasty looking black stuff came out after a good amount of air. Judging by the paint and grime on the zerks (cleaned them off with wire brushes first) they were never done by the dealer. and cleaned in interior (washed mats, vacuumed, wiped everything down). Good to see all the salt stains and dust out of it, a clean interior is so nice.

Now if I can just find an air freshener that's not overpowering for like 4 days and then you can't notice it... I've been using the Yankee candle hanging ones. Also don't like the air vent liquid ones, they seem to leave a film on the windows after a while.

 

Leave windows down overnight if it isn't snowing or raining...get that fresh ozone smell a'natural!

 

Alpine ILX-W650 installed. Echo through the phone to the caller. Going to try a firmware update this next week.

 

Scentsy makes a mini air diffuser that plugs into USB. It should fit perfectly in that half cup holder thingy near the usb ports. My wife has one in her 4Runner. They take little pods. Smells like lemon every time I turn the vehicle on. I know they make one that smells like leather, if that's more your speed. May be too much stink though, they are pretty powerful. https://scentsy.com/shop/c/26499/mini-fan-diffuser
https://scentsy.com/shop/c/4706/scentsy-pods

 

I hope the air you are referring to wasn't on the slip yolk part of the drive shaft. That isn't meant to be full of grease.

 

Rounding up the last few weeks of mods... 2017 TRD Pro Grille + Color Matched Hood Bulge, AJT Designs TSS Relocation, 25% Front Window Tint, DeeZee Bed Mat, JDM ASTAR LED Turn Signals (not pictured), 10" BAMuffflers Stainless System

 

Thanks for the link, might get one.

Which one is the slip yoke? Forgive my dumbness, I followed this (the rear most, the one point to 'C' which only had one zerk, and the front-most 'A'). I would say they all took the same amount of pumps to get grease out of the seals.
https://www.tundras.com/threads/wan...erly-lube-the-drive-shaft-in-my-tundra.29912/
https://www.tundras.com/threads/wan...e-shaft-in-my-tundra.29912/page-2#post-743612


So I may have hurt something doing this?

 

Did you put the resonator on the 10"? I have the same system and could not be happier. Sounds really good on the gas (on ramps with the noise barrier walls to the right, echos off good), but quiet once cruising. Did an 8 hour trip to Missouri last year and was totally fine, passengers fell asleep. BTW if you can, get someone to drive it and sit in the passenger seat, interestingly it does sound different than in the drivers seat.

Also, enjoy your nice new clean truck as is. I crawled around under it yesterday and it truly saddens me how rusty and nasty everything is. Even the hangers on the DD exhaust are rusting already (put on last July).

 

I haven't put the resonator on yet, just installed yesterday and drove around the neighborhood. I completely agree that the system is perfect, loud when you want it and quiet when you're cruising. I figure I'll wait until I get some highway miles in before deciding on the resonator. Also, I haven't done it yet but I plan on cutting back the tailpipe to dump just after the axle turndown (for clearance more than anything).

 

You can fit a 40in baja designs S8 in there with the @sdhq_offroad bracket

 

Can you post a link? I only see the 30”
https://sdhqoffroad.com/collections...rent-toyota-tundra-lower-bumper-light-bar-kit