2019 Tundra Front Bench Console

I have the front bench with the folding seat console in the front. With the factory cupholders, the drink cups flop all over the place while driving. Are there any custom inserts that can be purchased to alleviate the impending disaster of spillage? Thanks!

 

I have the SR5 but the cup holders in the shift console came with rubber inserts for 2 of them from Toyota. On the other two I found 2 rubber collapsible cups in the camping section of walmart. They work great.

 

Thank you for the reply! Did you have a link to what you bought? That link didn't seem to lead anywhere.

 

They put that link in! Just walk into the camping part, they are like 2$ each. My truck had two from Toyota in it when I took delivery.

 

I believe ppl have used some pvc pipe

 

or reducer ferncos from the plumbing section... definitely on my list to do, too. If i do it before you, i'll post the sizes that worked. I'm pretty sure someone else already has, but i dont have the thread handy.

 

3” rubber Coupling. You will have to make a relief cut so that way it fits in there

 

Bigger cups???

 

It’s the base that’s the problem. Rtic are to big and sit on a angle. If found the ZAK! Cups from target for the best.

 

The issue is that they are not always the same cups. Could be a chick fil a cup, chipolte, water bottle, etc.

 

This seems like the best solution so far... I'll have to test it out

 

Yep, I don't want a cup holder on the console. That's where the 20lb yorkie sits

 

Fernco Inc. P33U-305 Bushing, 3 Inch, Black

FERNCO P33U-305 Bushing, 3", Black

https://www.amazon.com/dp/B001ATFJOW/ref=cm_sw_r_cp_api_i_M4qMDbP88RD87
Had these in the truck since October 2016

 

Another good suggestion, thank you

Edit: ordered

 

Did you make that video on Amazon? Haha

 

Ordered the Fernco jobbers. Excited to finally use regular cups and cans!

 

Haha no

 

Same!

 

Got them in and they look good and fit well (•‿•)

 

I wish there was more we could do with this set up.

 

I actually 3d printed some spacers. It started out as cup spacers, and then evolved into nugget sauce holders...

 

Well that's not fair........showing us those nice printed cupholders and not offering to sell us some.........

 

or share the 3d model (for personal use of course) ;-)

 

I just joined this forum so I’m not sure what the rules are about selling and vendors etc. If you’d like I could probably print them at cost + shipping for people.

I thought I did! I’ll have to double-check, but if not I’ll put them up on thingiverse over the next few days

 

Ah, just remembered I never designed the cup spacer, just the nugget sauce holder. LMK if you'd like the nugget sauce holder, but the spacer can be found here:

https://www.thingiverse.com/thing:3558139

Creator says he printed in TPU, I printed in PETG and it was fine.

 

Lol