Choose my Offset

What's up everyone!I So I'm looking into getting aftermarket 20's to run w/ my factory 275/55R20 Dunlops until it's time for new tires. I'm having a hard time deciding on an offset to match my OE flares, even after thoroughly searching. I measured and the flares stick out about 1.75“ from the wheel. I've narrowed it down to two choices.
+1 or +20.
What is everyone's opinion or thoughts on what I should do? Side note: I may eventually lift/level on a 3/1. Thanks in advance!

 

I have a 3/2 with 285/70/18's on a +1 offset with Bushwackers. I'll take some pics in a little while.

 

According to tiresize.com's wheel offset calculator ( ), the +20's will make your wheels stick out another 1.57" and the +1's will have them out 2.32"

So how aggressive do you want it to look? The +20's will get you close to flush. The +1's will have you out about 1/2" past the flairs. If you go with larger (wider) tires later, they will stick out even more. Personally I'd go with the +20's

 

Damn, thanks for the input. I'm not sure how aggressive I want to go. I've been going through photos of Tundra offsets trying to figure out.

 

i have 20's with zero offset; gives it an aggressive stance. no fender flares.

 

Got a photo?

 

Thanks! This one really puts it into perspective.