VLEDS VLR 6 Duo Turn Signal Module

Pair of VLR 6 Duo Hyper flash modules. Bought wrong part by mistake will not work for Tundras to my knowledge.
Asking $25 shipped OBO to lower 48.

Info from website:
Exclusive The VLR is by far the cleanest and safest way to add load to any vehicle lighting system. VLR resistors accomplish the same task as a common gold resistor but are easier to install, have a lower profile, and run 50% cooler (250°F MAX).

One for One We get asked all the time, how many resistors will I need? The answer is simple: If you're removing a filament turn signal bulb add one VLR-6 in its place. It's like balancing a scale; if you remove weight, the scale will be unbalanced, so you're simply putting the same amount of weight (load) back on.

Construction Using a wire wound resistor potted inside of a black anodized aluminum heat sink, these are the most weatherproof and thermally safe resistors on the market. VLR resistors use high temp silicone wiring attached to a male waterproof circular connector.

Mounting The supplied VLR High Temp mounting tape can be used to adhere the resistor body to a flat, clean metal surface on the vehicle. As an extra precaution: VLR resistors should be mounted out of harm's way and should not touch any plastic or other wiring.

For exterior applications we recommend filling the DuoTap with our dielectric grease.

TECHNICAL SPECS
Current Draw: 1.9A @ 12V | 2.25A @ 14.4V
Each Resistor= 1 standard filament bulb (equivalent wattage: 25W)

 

When did you buy them? They have excellent customer service and would most likely swap them out for you.

 

About 2 years ago. I got them in, realized I ordered the wrong ones and just ordered the right ones and threw these in my stash.

 

TTT

 

TTT

 

TTT

 

TTT