Vario Driver Seat sensor issues Solved

I changed out my drivers seat for the custom Scheel-Mann seat.
I found a plug that fits into one of the sensors to bypass but the actual airbag in the seat I've not found a bypass that works.
As such was removing it to put it under the seat in a square metal pipe to avoid it expanding and when I went to remove from the seat bracket it has what I believe to be an 8 point bolt.

I've not had luck searching online to narrow down the exact size.

Does anyone know off hand what size/patter of bolt holds the air bag and air cylinder in place on the drivers seat?

 

That would be known as torx, you can pick up a set at harbor freight relatively cheap

 

its the male version and 8 point not six, I have torx drivers and sockets, this is the inverse unfortunately and really hard to use a regular pair of pliers on, found a few 8 point female sockets but before purchasing wanted to see if anyone knew the actual size as some sets run pretty expensive

 

As it turns out, it was a 6 point and with the star pattern an 11mm-7/16 deep socket frees the nut and I was successful in removing the air bag.
Part 2 is that the seat position sensor which is a magnet sensor was removed with a T 30.
Once I plugged both in to my Tundra all the warning lights went away and no more constant audible/visual alerts every time I turn my Tundra on.