1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Updated MagSafe holder for 3D print

Discussion in '3rd Gen Tundras (2022+)' started by raylo, Aug 22, 2025 at 8:40 AM.

  1. Aug 22, 2025 at 8:40 AM
    #1
    raylo

    raylo [OP] not so new member

    Joined:
    Oct 1, 2021
    Member:
    #68780
    Messages:
    2,446
    Gender:
    Male
    Frederick, MD
    Vehicle:
    2023 SR5 DC 6.5 bed Lunar Rock, TRD OR +Options
    DashCam, amp & sub, DIY rear seat delete, cat shield, AMP power boards
    So, I have had this holder up on Thingiverse for a long time for Qi and Magsafe chargers but one issue I ran into recently was my GF got a new and bigger phone so the charging puck didn't line up with her phone properly. So I came up with a new design that essentially makes trays into which you snap separately printed puck holders that can be placed anywhere along the trays in the base. You can see in the photo how the one on the right is higher than the one on the left for my iPhone 16 Pro. Print the base and the left and right puck holders.

    https://www.thingiverse.com/thing:5846453
     
    Jymbeux and 60centenergy like this.
  2. Aug 25, 2025 at 7:02 AM
    #2
    sc taco

    sc taco New Member

    Joined:
    Apr 29, 2023
    Member:
    #96227
    Messages:
    28
    Vehicle:
    2023 Tundra 1794 TRD
    This is awesome. Thanks.
     

Products Discussed in

To Top