turbo 4.7 tundra

been their done that pull the engine and set up every thing. you need to drill upper oil pan and tap it and install a bung for oil return. sounds rear stupid but i used a 5/8 natural gas line like you buy for a hot water tank 5/8 24 long with 1/2 in fittings. it conforms to any shape and heat from pipes wont burn it like rubber line. you need to reconfigure you power steering line to clear
pipes. relocate resivore to front of apron it is not a weekend project. oh the rods will snap at 8 psi boost so with engene out put set of h beam rods if your going past 5 psi boost. at 20 psi boost trans will no like you. nor the bearins uf your crazy u can us a 3uzfe and bore it 30 over to make it a 4.7 with 6 bolt mains and realy make power

 

You may want to put that tidbit of info in your old post...
https://www.tundras.com/threads/2000-tundra-turbo.106436/page-2#post-2743716

Glad you turned off the all caps.