1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Tundra Long Tubes on a 2016 Sequoia

Discussion in '2nd Gen Tundras (2007-2013)' started by M_RED, Dec 8, 2022.

  1. Dec 8, 2022 at 4:27 PM
    #1
    M_RED

    M_RED [OP] New Member

    Joined:
    Nov 21, 2022
    Member:
    #87085
    Messages:
    38
    Gender:
    Male
    2 Part Question: Long Tube Headers

    Where in the exhaust system would a Long-tube header and cat back system for a Tundra stop being compatible with a 2nd Gen Sequoia? Am I going custom at the rear axle or further forward?

    2nd Question,,, Installation... Are long tubes a day project? Solo Weekend Project? Or rent a lift and bribe friends for a terrible experience and much blood loss?

    I'm hearing that one should avoid the Doug Thorely shortys, Kooks, JBA and Stainless works all make long tubes. Can anyone share any experience installing those?

    And Yes, I have access to a MPVI3 for the tune to actually take advantage of them...

    Any advice will be greatly appreciated
     

Products Discussed in

To Top