1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Toyota Tundra/Sequoia front dust shields rusted out

Discussion in '1st Gen Tundras (2000-2006)' started by 1Piratsun1, Apr 22, 2023.

  1. Apr 22, 2023 at 9:25 PM
    #1
    1Piratsun1

    1Piratsun1 [OP] New Member

    Joined:
    Apr 22, 2023
    Member:
    #95883
    Messages:
    6
    Gender:
    Male
    Vehicle:
    2003 Toyota Sequoia, 2fe-uz
    none
    2003 Sequoia 4x4 227k miles, should be the same deal for 1gen Tundra.
    Passenger side front dust shield rusted off, bottom portion fell off.
    To install whole new oem dust shield you have to press out the hub which I didn't want to do:))
    What I did, I have cut it into 2 sections, upper and lower.
    Some people just cut off small section off of it and install it. I wanted my whole part to be there.
    I think it has 3 bolts. Use silicone or gasket maker to take care of the seam. I used black silicone which I had laying around.
    Make sure you clean all the rust while the old shield is off.
    Good luck wrenching:))
     
    Mustanley, w666 and Tundra2 like this.

Products Discussed in

To Top