1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Short in A/C system

Discussion in '2nd Gen Tundras (2007-2013)' started by Toytundra10, Jul 7, 2024.

  1. Jul 7, 2024 at 3:54 PM
    #1
    Toytundra10

    Toytundra10 [OP] New Member

    Joined:
    Sep 28, 2019
    Member:
    #36722
    Messages:
    12
    Gender:
    Male
    Hello,

    Has anyone had a short in their a/c sytem?

    2010 Tundra 5.7. A/C was working fine last year, not working at all this year.
    Replaced the clutch, checked the freon with gages, replaced the relay.

    It had the dreaded a/c flashing light on dash.

    I can apply power to the #3 on the relay and the clutch will pull in and it will start to get cold in truck.

    But when I put relay back in and turn on a/c the 10 amp fuse under the dash blows.

    I'm at a loss. Jumping out the relay should tell me the compressor is good. The pressure switch has continuity with engine off.

    Any advise will help before it goes to a shop.

    Thanks

    Bob
     

Products Discussed in

To Top