1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Routing rear camera wiring to cab

Discussion in '2nd Gen Tundras (2007-2013)' started by TXTundraFan, Oct 25, 2020.

  1. Oct 25, 2020 at 8:59 AM
    #1
    TXTundraFan

    TXTundraFan [OP] New Member

    Joined:
    Jun 18, 2020
    Member:
    #48138
    Messages:
    167
    Gender:
    Male
    I'm getting a Master Tailgaters replacement tailgate handle with backup camera and should be getting my new radio later this week. I don't have a lift and was wondering how y'all have routed the wiring under the bed and into one of the rubber grommets under the rear of the cab? My truck is on its stock 18" wheels/tires until later when I am swapping them for 20" wheels.
     
  2. Oct 25, 2020 at 11:57 AM
    #2
    Gto7419

    Gto7419 New Member

    Joined:
    Jul 19, 2020
    Member:
    #49571
    Messages:
    64
    Vehicle:
    2010 Tundra
    I used the bushing just rear of the intake on the pass side firewall. Put the wire in wire loom and zip tied to the current wiring harness on the pass side frame rail. Looks like stock.
     

Products Discussed in

To Top