1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rear spring choices

Discussion in 'Suspension' started by lr172, Nov 7, 2024.

  1. Nov 7, 2024 at 7:16 PM
    #1
    lr172

    lr172 [OP] New Member

    Joined:
    Sep 27, 2024
    Member:
    #123527
    Messages:
    253
    Gender:
    Male
    Vehicle:
    07 DC
    Still working through issues on my new 07 DC. Have the bed off to deal with the classic bed rot. Once it was off it looked like the frame was twisted, then realized the drivers side leaf spring is sagging about 2” more than the other side. No obvious cracks, but haven’t looked real close yet.

    i can get a pair of husky springs shipped for about $370 fromRA. I also found a local guy parting out an 08 near me and can get his springs for 120. He says 170k miles. Am a bit worried that his springs are worn out as well. I would trust coil springs that old, but wonder about leafs.

    looking for experience from the group. Is my situation unique or is it typical for these leaf springs to do this with age. Don’t mind spending the money for new, but would like the savings of used it works out.
     
  2. Nov 7, 2024 at 8:02 PM
    #2
    KNABORES

    KNABORES Sarcasm incoming

    Joined:
    Jan 1, 2020
    Member:
    #40572
    Messages:
    13,736
    Gender:
    Male
    Arkansas
    Vehicle:
    2000 Limited TRD AC 4X4 Thunder Grey 278k miles. *SOLD* 2019 Limited TRD CM 4x4
    Bilstein 5100's on the forbidden notch Husky HD rear leafs 16x8 Eagle Alloy 187's with 285/75/16 MagnaFlow 3" flow through Pioneer touchscreen with backup camera Full interior and dash LED conversion Trailer brake controller with 7 pin Bedliner coat bumpers & trim ARE Mpulse topper - Rhino Vortex rack
    I replaced my stocks with Husky HD from RA on my 2000 and have been very happy with them. They support an additional 500#. Doesn’t change payload, but nice to handle the weight better. Only about 3/4” taller than factory ones were.
     
  3. Nov 7, 2024 at 9:05 PM
    #3
    lr172

    lr172 [OP] New Member

    Joined:
    Sep 27, 2024
    Member:
    #123527
    Messages:
    253
    Gender:
    Male
    Vehicle:
    07 DC
    I don’t haul a lot of heavy stuff, so hadn’t considered the HDs. Did they siffen up the ride with the bed empty?
     
  4. Nov 8, 2024 at 2:25 AM
    #4
    KNABORES

    KNABORES Sarcasm incoming

    Joined:
    Jan 1, 2020
    Member:
    #40572
    Messages:
    13,736
    Gender:
    Male
    Arkansas
    Vehicle:
    2000 Limited TRD AC 4X4 Thunder Grey 278k miles. *SOLD* 2019 Limited TRD CM 4x4
    Bilstein 5100's on the forbidden notch Husky HD rear leafs 16x8 Eagle Alloy 187's with 285/75/16 MagnaFlow 3" flow through Pioneer touchscreen with backup camera Full interior and dash LED conversion Trailer brake controller with 7 pin Bedliner coat bumpers & trim ARE Mpulse topper - Rhino Vortex rack
    Didn’t seem to. They make the regular capacity ones too though.
     

Products Discussed in

To Top