1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Power steering pressure switch connector

Discussion in '2nd Gen Tundras (2007-2013)' started by B-rad, Jan 23, 2024.

  1. Jan 23, 2024 at 6:18 PM
    #1
    B-rad

    B-rad [OP] New Member

    Joined:
    Jan 23, 2024
    Member:
    #110739
    Messages:
    2
    Gender:
    Male
    Hello everyone, I have a 2011 tundra Rock warrior, recently my CEL came on with the code for power steering pressure switch. Wile replacing said sensor I noticed that 2 of the 3 wires coming from the plug-in that goes into the sensor had been pulled out. Has anybody here ever replaced the plug for that sensor and how hard was it? And how do I go about finding that specific part iv been looking online and can't fine the plug itself just a replacement sensor. Thanks!
     

Products Discussed in

To Top