Passenger side weathertech mat sliding fix

I got tired of the passenger side weathertech mat always sliding forward since the provided spike pad arrangement is useless, so I snagged a set of the eagle klaw floor mat clips. However, instead of drilling/punching a hole for the eagle klaw screw, I 3D printed a screw holder that uses the existing holes in the weathertech mats. You can easily tighten or loosen the screws by hand, making it a cinch to pull the mat out of the truck for cleaning.

 

Very Nice

 

Do you happen to have the STL for this still? I have the same problem with my weathertech mats and just got eagle klaw clips too.