1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

O2 Sensor NO 5 volts reference

Discussion in '1st Gen Tundras (2000-2006)' started by Cope, Aug 3, 2021.

  1. Aug 3, 2021 at 11:34 AM
    #1
    Cope

    Cope [OP] New Member

    Joined:
    Aug 3, 2021
    Member:
    #66314
    Messages:
    1
    Gender:
    Male
    First Name:
    T
    Vehicle:
    Toyota 4.7
    Hello new to this message board. O2 sensor Bank 2 sensor 1 has NO 5 volt reference. The reference voltage is present at the bank 1 sensor 1. Not sure if there is a fuse or if the Control Module is bad. Any help would be good.
     
  2. Aug 4, 2021 at 7:10 AM
    #2
    mbreed2

    mbreed2 Is not right

    Joined:
    Jun 21, 2021
    Member:
    #64594
    Messages:
    181
    Gender:
    Male
    Allentown PA
    Vehicle:
    2001 Tundra 4x4
    Wiring diagram has been posted on here before. You can run a search and find it.
    I have never heard of this issue personally.
    Usually the O2 heater circuit will have a fuse, not the reference voltage.
     

Products Discussed in

To Top