1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Mode actuator motor install

Discussion in '2nd Gen Tundras (2007-2013)' started by Parker_77, Aug 13, 2025.

  1. Aug 13, 2025 at 6:50 PM
    #1
    Parker_77

    Parker_77 [OP] New Member

    Joined:
    Aug 13, 2025
    Member:
    #139272
    Messages:
    6
    Gender:
    Male
    Vehicle:
    2007 SR5
    My HVAC mode actuator went on my 07, I pulled it all apart and replaced the 2 motors on the assembly. But am having a hard time getting them back in. I cannot get all the pins and gears to line up properly, is there anyone else on here that has had this issue before?
     
  2. Aug 13, 2025 at 7:04 PM
    #2
    blackdemon_tt

    blackdemon_tt Battery Slayer

    Joined:
    Feb 27, 2020
    Member:
    #43241
    Messages:
    3,198
    Gender:
    Male
    Vehicle:
    2007 5.7l Tundra DC SR5 long bed 2wd
    TRD Sway Bar, Roll covers USA bed cover
    I took a screenshot of someone whonposted the easy way to put them back. That was my old phone, but I'm sure you can find it on here somewhere.
     

Products Discussed in

To Top