King 2.5 coilover lift ?

Greetings. Built some old cars but this is my first lifted Tundra. Nice forum here.

23 Trd off road with currently Westcott kit on it w/ 35s. I will be installing/swapping for a King 2.5 coilover kit with reservoirs and Camburg tubular uca this weekend. Lots of mixed info out there on how much lift they are out of the box. I’d rather not do this twice to adjust front height. I’m looking to set the front height at 2.25-2.5” of lift over stock. I will keep my 7/8” rear spacer puck so I’d like to keep the slight rake.

Hopefully someone has a measurement of threads needed or the amount of turns they made on the adj. collars? TIA

 

@AccuTune Offroad

 

From Kings directly ,
About 2" out of the box for a base, non hybrid
Expect a little less with a hybrid.
Suggest to install them, lower the truck on the ground drive around the block few times and measure
Kings are easy to adjust Lift one wheel at the time from the chassis so the wheel is at full droop, loose that allen key one turn at the time and start rotating gently
Do an alignment after.

 

Thank you. The TRD off road already has some lift in it. So would it be stock height on a Trd? I’ve adjusted some qa1 coilovers on a car but King doesn’t look so easy to compress and turn the adjustment collar on the vehicle. Not recommended according to instructions

 

Call King directly and ask them.

 

I did call King directly and got two different answers. Called before ordering and now that I’m getting ready to install. One said an inch and other said two lol