1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Just installed new engine, no start, no fuel

Discussion in '2nd Gen Tundras (2007-2013)' started by Danjojo55, Oct 11, 2019.

  1. Oct 11, 2019 at 6:47 PM
    #1
    Danjojo55

    Danjojo55 [OP] New Member

    Joined:
    Sep 6, 2019
    Member:
    #35706
    Messages:
    25
    Gender:
    Male
    Vehicle:
    2011 Tundra
    I’ve just completed a engine install on my 2011 tundra. I pre oiled and cranked briefly. Installed plugs and attempted to start. Cranked but no start. Disconnected one fuel rail, cranked but no fuel. Did not hear fuel pump run either.
    Did not have this problem before the engine change.
    I will start looking at this challenge tomorrow, all suggestions welcome.
     

Products Discussed in

To Top