1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Hewit Bypass ?

Discussion in '2nd Gen Tundras (2007-2013)' started by whiteboysteve, Jul 12, 2024.

  1. Jul 12, 2024 at 7:30 PM
    #1
    whiteboysteve

    whiteboysteve [OP] New Member

    Joined:
    Jul 12, 2024
    Member:
    #119805
    Messages:
    1
    Gender:
    Male
    First Name:
    Steve
    Vehicle:
    2010 Tundra
    2010 5.7 / I installed the Gen 2 Hewitt bypass kit a couple of years ago and it has worked great (I forget my original code though). I had a new condenser installed and then a few hundred miles later it went into limp mode with codes of P2441 & P2445. Any thoughts?

    Thanks
     
    Last edited: Jul 13, 2024
  2. Aug 1, 2024 at 4:58 PM
    #2
    kanger328

    kanger328 New Member

    Joined:
    Jun 3, 2020
    Member:
    #47511
    Messages:
    122
    Gender:
    Male
    Anchorage, Alaska
    Vehicle:
    2012 DC 4x4
    I had my truck go into limp mode a few years after the bypass install. I disconnected then reconnected the bypass kit and cleared the code. Has run fine since then.
     
  3. Aug 1, 2024 at 6:31 PM
    #3
    Ponderosa_Pine

    Ponderosa_Pine

    Joined:
    Sep 14, 2022
    Member:
    #83377
    Messages:
    1,133
    Northwest
    Vehicle:
    2021 Tundra DC, 2022 4R, 2007 FJ
    Magnuson Supercharged, Dobinson Lift, 315/70r17 on Rockwarriors, Heftyfab bumper, Dirty Deeds 3” race exhaust
    Yeah I get occasional codes with the gen2 kit and just clear them and they don’t come back for months/etc.
     

Products Discussed in

To Top