FS: '21 Pro OE Rigid Fog Light Assemblies $300

I am selling the left and right Rigid Industries fog light assemblies which were removed from my '21 Pro at about 25k miles. I ran them w/the Rigid amber covers (included) for about 95% of their time in use, and those covers did a good job protecting the lenses from rock chips, etc...

They function as intended and have what would be normal wear and tear for something that is embedded into your front bumper for 25k miles... see pics below for condition.

These are Toyota part #s: PT228-34190-AC and PT228-34190-AD, which is the entire fog light assembly, as shown below. MSRP from Toyota on these is a ridiculous $456/per side, but they can be bought new from Fred Anderson and other online dealers right now for just under $540 for the pair including current discounts and free shipping.... The included Rigid amber lens covers were about $20-$25 iirc.

So, I'm asking $300 shipped for the pair w/covers to anywhere w/in the lower 48...

To my knowledge, the Pro was the only trim w/the square fog light bezels and assemblies, and I retained my bezels because I replaced these w/another Rigid product. The other OE bezels (trim pieces) that I've seen on Tundras are all round, so unless you already have the square bezels you'll need to purchase them as the OE round bezels will not work w/these fogs. They would be part#s: PT228-34190-AA and PT228-34190-AB and can be had for about $56 shipped for the pair through Fred Anderson w/the current sale.

I would assume as long as you have any of the OE fog light assemblies that wiring would be plug and play, but please do your own due diligence to verify compatibility with your current vehicle and its set up...

Here are several photos of them from when I pulled them out of the vehicle and prior to cleaning them up or anything.

Right assembly


Left assembly


Right side up and upside down views of the assemblies



Close ups of the lenses





Rear of the assemblies



Lens covers have a bit more scratching to them, but again it kept the fog lens itself pretty clean and minimal scratches with them on. These clip over the light and sit between the light and bezel. The (2) screws help secure the fog light assembly to the OE bezels.

 

Tues morning....



PS>> This is what happens when you sport doesn't have cheerleaders and some J-A$$ decides to make a mockery of the players by having them do stupid shit!!!!

 

Cru bump

 

hey there. id be happy to take these off your hands.

 

PM sent