Fog light install on 3rd Gen SR

Hey all! New to the forums. Been looking through the threads and have found a lot of helpful info. One thing I haven't found is adding fog lights to a 2024 SR model. The spot on the bezel is molded over with no way to pop anything out to make room for the fog lights. Would I need to cut these spots out for the fog lights? What all is required to install a factory set of lights and has anymore done this before? Thanks in advance!

 

Welcome to the forum bud, from what I've read you will need to order that lower bumper piece with the fog lights cut out already. There are spots where the fog light attaches to the back and I don't believe your piece has that bracket. I could be wrong but this is what I found when looking around.

 

Buy the OEM fog lights that are for sale on marketplace right now. Get a new piece with already cut out holes, or you can use a dremel tool to cut out on the one you currently have. Harness can be bought of eBay for like $18, but when I did that it didn’t work and I had to reverse the negative and positive that lead to an each bulb. Connect to battery, run the wire through the grommet to interior, and plug the switch into one of the empty slots

 

Thanks for the replies! I was looking at the new bezels and they are $150ish. Not too bad, was hoping for an option to use what I already had to save some money.

 

Hey everyone, I’m new to the forum and fairly new to owning a Tundra. Ended up buying a 22 SR crewmax 4x4 midnight metallic black. I have been looking everywhere online trying to figure out the fog light situation on a 3rd gen SR. I ordered a pair of rigid industries amber lights and also the TRD grille with raptor lights and a 20” light bar. Then I realized the fog light bezel has no pop outs where the fog lights go so I ordered the TRD fog light bezel with a place for fog lights already cut out. Is there anybody else out here that’s done this mod? The grille lights came with a switch and harness but I had to order a wiring harness for the rigid fog lights. As my tundra does not seem to have any pre wiring installed… any advice and help would be appreciated. Thanks!