1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Driveline Clunking after Lift

Discussion in '2nd Gen Tundras (2007-2013)' started by MODRUMMER, Jun 11, 2024.

  1. Jun 11, 2024 at 11:57 AM
    #1
    MODRUMMER

    MODRUMMER [OP] New Member

    Joined:
    Jun 11, 2024
    Member:
    #118278
    Messages:
    1
    Gender:
    Male
    Hey everyone, I have a 2008 tundra that I installed a 3/2 lift on (basic plate on top of shock, blocks in rear, diff drop). I have a clunking noise that increases with speed on the drivers side. Sounds like the front diff/CV axle area. Basically get a clunk for every rotation of the wheel. What could this be?
     
  2. Jun 19, 2024 at 5:36 AM
    #2
    blackdemon_tt

    blackdemon_tt Battery Slayer

    Joined:
    Feb 27, 2020
    Member:
    #43241
    Messages:
    3,050
    Gender:
    Male
    Vehicle:
    2007 5.7l Tundra DC SR5 long bed 2wd
    TRD Sway Bar, Roll covers USA bed cover
    You're gonna have to double check all the bolts and parts installed. Check your sway bar end links, these are commonly left untighten since they have a 2-step process to completely tighten them down. I would start there and move out to the other components.
     

Products Discussed in

To Top