Cup Holder for SR5 split-bench Tundra?

Hi there.

I just purchased a 2020 Tundra SR5. I had to get a split bench front seat to accommodate the kids for trips. When I put the center organizer up to make a middle seat for my son, I lose my cup holders! Does anyone know of any good aftermarket velcro or other type to possibly add to the hump on the floor board? Thanks in advance.

 

This is the smaller consoles I’ve used to gain two cup holders. You could fasten it to the floor or Velcro it. It has enough room to lift the bottom of the seat to access the middle extra storage. Hope that helps.

Hopkins EMIC-BLA Go Gear Euro Mini Console, (Black)

$26 GO GEAR EMIC-BLA Euro Mini Console, (Black)

https://www.amazon.com/dp/B000FGLQCK/ref=cm_sw_r_cp_api_i_QBGpFb8KNGHXQ

 

There is also this one but I haven’t tried it out. It’s similar to the first one but without as much storage.

This one is pricey on Amazon but I believe auto zone has it cheaper I’ve seen it there in the organizer selections of the storage

Hopkins SMT Go Gear Twin Cupholder, (Black)

$20 Go Gear SMT Twin Cupholder, (Black)

https://www.amazon.com/dp/B000FGIBYQ/ref=cm_sw_r_cp_api_i_9GGpFbKRHHR6B

 

I used this one. It works pretty well. If you have somebody sitting in the middle seat though, their feet will be in it.

 

Perfect! Thank you.

 

Thank you!!

 

Not proud of the aesthetics, but here’s my solution to the lack of floor mounted cup holders. Can’t believe Toyota couldn’t add a little pull out cubby like most other bench trucks.