Control arms question ('05 & '08)

Hello from Texas y'all.

I have these two Tundras, both 2WD and with factory lift, and both have the same problem...front suspension so worn out they definitely need replacement. While I have each up on the lift I think I will just yank most of that gear out rather than replace those ball joints and all those bushings, etc...

I have heard that the upper control arms can be a PITA, but cannot verify. Any tips on the replacement of those? Knowing that these rigs are two different generations, any distinct suspension install differences?

Also, if anyone has recommendations on moderately priced, decent quality, upper and lower control arm combo kits it would much appreciated!

Thanks,

Craig