1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Collision Avoidance Light On

Discussion in '2.5 Gen Tundras (2014-2021)' started by bdk, Jun 19, 2020.

  1. Jun 19, 2020 at 4:30 PM
    #1
    bdk

    bdk [OP] Just an Old Retired 1SG

    Joined:
    Jul 10, 2019
    Member:
    #33054
    Messages:
    18
    Gender:
    Male
    First Name:
    Dennis
    Hopkinsville, KY
    Vehicle:
    2019 Cement Limited
    I installed the radar relocation bracket from JoMax Customs today. Before putting my new (2017 Pro) grill on, I took it for a test drive to make sure the collision avoidance light didn't come on. It was fine and all was good for a few trips around town. I was driving to Ft. Campbell, KY today and the light came on and stayed on until I turned off truck. I immediately started it and the light was not on. A few miles down the road, it came back on again. My last trip today was 10 minutes and no light. Sporadic at best. Any suggestions or ideas?

    Thanks!
     

Products Discussed in

To Top