1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Clunking when putting truck in drive, plug came loose in drive shaft??

Discussion in '2.5 Gen Tundras (2014-2021)' started by WV Boy13, Jun 20, 2023.

  1. Jun 20, 2023 at 9:59 AM
    #1
    WV Boy13

    WV Boy13 [OP] New Member

    Joined:
    Jun 20, 2023
    Member:
    #98909
    Messages:
    1
    Gender:
    Male
    After reading some on the boot replacement on the rear driveshafts on 2016 tundra, I questioned a local mechanic about a clunking when shifting in to D or R...said there is a cap/plug inside the boot around the yoke that I'd see if I took it out to investigate. When I do this does anyone know where the cap/plug goes and if I can get it back to where it needs to be?
     

Products Discussed in

To Top